A mobile sauna is a structure that allows you to enjoy a pleasant stay during a camping trip. Its installation requires no engineering or design skills. The first rule is to avoid traditional design. A stove will be the heat source. It is assembled where the portable sauna is planned to be used. Firewood and stones are collected for operation. They are laid out in layers and then lit. This reduces the cost of the structure.
Selection of material
Assembling the frame begins with choosing the material. Depending on the climate, polyethylene or tent fabric is used. The latter is preferable as it weighs less and lasts longer. The second element is the poles:
- aluminum;
- carbon fiber.
If you don't have anything similar on hand, poles from a standard 4-5-person tent will do. Wood should not be used for poles, as it is flammable and cannot withstand high humidity and temperature fluctuations.
Selecting the right size
When planning the structure, consider the fact that each person has at least 1 square meter of space. For example, if a group of 5 people uses the steam room, the structure's area will be 5 square meters plus 1/3 of the extra space. The next step is creating the awning. An old tent will do. Don't use material left over from modern tents. The fabric will quickly deteriorate due to humidity and high temperatures. A tarpaulin is the correct solution.
Operating Rules
Water, stones, and firewood are the three essential components. The portable sauna should be installed near a permanent source of firewood. The recommended diameter is 10 cm. Firewood that is too thick takes a long time to ignite, while thin firewood doesn't generate much heat.
Before using the mobile steam room, prepare a bucket of large, round boulders. If none are available near the campsite, pebbles will do the trick. Another requirement is that there should be a body of water near the steam room. A dam is built nearby for bathing.
Furnace arrangement
The longer people plan to stay in the steam room, the more boulders and firewood they'll need. The next step is the actual assembly:
- 1 layer of firewood is laid on level ground;
- it is covered with a layer of stones;
- The "layer cake" continues to be laid out until the stones run out;
- The top of the "pie" is always the stones.
The stove assembly is carried out close to the frame. The less time it takes to transfer the hot stones from the stove to the steam room, the better. Installation bake It's possible to use a mobile steam room if guests prefer extremely high temperatures. Skeptics will argue that this option is unjustified. The risk of fire increases significantly.
Assembling the frame
Support poles are secured in a crisscross pattern near the fire pit. The elements are connected using electrical tape or strong rope. The next step is to assemble the awning:
- You can start doing it immediately after the stones have heated up;
- a small depression is created in the middle of the base;
- a heat source is placed inside it;
- they are pulling up the awning.
You may be interested in:Its edges are weighted with sand or logs to prevent structural collapse. As a result, the company has created a mobile sauna. Its service life depends on the intensity of the load.